Shottower 5
von Spotkiller
32
Downloads
39
Likes
0
Makes
https://youtu.be/jdUvaTwTH38
I designed this Tower to fill 5 shot glasses at once.
Print with no support.
Maybe you have to sand down a bit on the square of the feet to fit the top part.
Better you glue it together.
There is an Adapter now, which you can put in the middle. it will raise the Top part by 12mm to fit bigger shot glasses
I recommend to use for the Top Part some Filament which is food safe.
I designed this Tower to fill 5 shot glasses at once.
Print with no support.
Maybe you have to sand down a bit on the square of the feet to fit the top part.
Better you glue it together.
There is an Adapter now, which you can put in the middle. it will raise the Top part by 12mm to fit bigger shot glasses
I recommend to use for the Top Part some Filament which is food safe.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
