Shower Caddy Mount

My wife bought us a shower caddy that went over the shower pipe for various stuff in the shower, but the shower head had a hose that interfered. So I designed a simulated pipe in TinkerCAD ( with a bit on the end to prevent it sliding off ) that allowed us to mount it at the back of the shower.

It's a simple design, but if you need one, it'll save you the 10 minutes it would take to duplicate, so there's that.

Printed in White Overture PLA+, 220C nozzle temp, 60C bed temp, no supports or adhesion needed. It's meant to be attached to the wall with double sided thin foam sticky tape, like 3M VHB. If you're concerned about how well the tape will hold up to water, add a thin bead of caulk around the top and the sides once it's stuck down.

P.S. First upload, first 3d design!