Thingiverse
Shower head adapter
by Djinns
1
Downloads
4
Likes
0
Makes
Print flat on the top part (thicker section)
Any filament is good, I used 100% infill with a 1mm nozzle and 0.5 mm layer height.
The reason for this is that I bought an Ikea showerhead, turned out not to angle downwards but at a 45 degree angle. This adaptor helps to hold it and angle downwards, no more wasting water ^^
Any filament is good, I used 100% infill with a 1mm nozzle and 0.5 mm layer height.
The reason for this is that I bought an Ikea showerhead, turned out not to angle downwards but at a 45 degree angle. This adaptor helps to hold it and angle downwards, no more wasting water ^^
Djinns also publishes on
13 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
