Thingiverse
Shower head holder extension
por veli0s
12
Descargas
10
Likes
0
Makes
The holder for my shower head is mounted too low for me (or i'm just too tall) so his is just a basic extension to increase the height so i don't have to duck to shower - measurements are fine for my setup, no clue if there is a standard for those things.
printed in ABS with supports, no raft, 20% infill, 0.3mm layers
edit (6/6/16): could use a little more reinforcement at the top... added a model with 3mm thicker outer walls.
marking this as work in progress until i found a good way to reinforce this, funny enough, the bottom part is pretty stable but the top holder is probably going to rip the layers apart. thinking about adding a screw on ring on top to reinforce it.
PLEASE be careful, depending on how you print this (or what shower you use it with - it might not be strong enough. i've only used it for 2 days so far and i'm still alive :)
printed in ABS with supports, no raft, 20% infill, 0.3mm layers
edit (6/6/16): could use a little more reinforcement at the top... added a model with 3mm thicker outer walls.
marking this as work in progress until i found a good way to reinforce this, funny enough, the bottom part is pretty stable but the top holder is probably going to rip the layers apart. thinking about adding a screw on ring on top to reinforce it.
PLEASE be careful, depending on how you print this (or what shower you use it with - it might not be strong enough. i've only used it for 2 days so far and i'm still alive :)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
