Thingiverse
Shower head holder replacement
door Jamez83
4
Downloads
3
Likes
0
Makes
Our holder for the shower head broke off, so i made a new one.
The height is adjusted so when it is at it's lowest stand, the shower head is horizontally.
Diameter of the inner hole = 16,4mm
Outer hole = 20mm
Height = 40mm
Loft is 24mm to 18,5mm
Supports only for the highest part of the outer holes.
40% infill at least
PLA will do
The height is adjusted so when it is at it's lowest stand, the shower head is horizontally.
Diameter of the inner hole = 16,4mm
Outer hole = 20mm
Height = 40mm
Loft is 24mm to 18,5mm
Supports only for the highest part of the outer holes.
40% infill at least
PLA will do
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!