Shower Head Holder

My take on the topic somewhat matching the legacy installation.

Fits 18mm vertical posts and Standard conical shower hose fittings.

Requires in addition to the four 3D printed parts:
1 screw M4 x 15 (20mm also still fits) with countersunk cone head.
1 melt-in M4 x8mm insert nut.

Print:
Print upright with classic support structure.
Filigran sun/clockdial patten facing up, screw threads facing up,

Assembly:
Melt insert into main piece at center of sun/clockdial end to be flat and even with surrounding surface.
Insert lock back into cener piece than slide over vertical post in your shower.
Tighten (easy!) knob onto screw until the assembly stays in place.
insert screw on shower head side of mount. Place mount in desired angle on center piece and tighten screw (easy!).
ATTENTION:
There is a front- and a back side of the shower head mount!
The front has a larger diameter and the back side is smaller.
Reversing orientation might break the mount. (been there, done that!)