Thingiverse
Shower head holder
von deflektor
6
Downloads
2
Likes
0
Makes
Short
--------
Replacement for a broken shower head holder.
Details
--------
As the original shower head holder was broken at the point where it is attached to ring, I took the opportunity to design one with FreeCAD for the first time. The design has one fault, but which was as the original one. The vertical movement is blocked at 10 degrees, I would allow more movement here (about 30-40 degrees), as you may want to lower the shower head.
Printing
--
I used to print this with 40 % infill, but you may reduce this further.
Source
---
https://github.com/deflektor/3ddesign
--------
Replacement for a broken shower head holder.
Details
--------
As the original shower head holder was broken at the point where it is attached to ring, I took the opportunity to design one with FreeCAD for the first time. The design has one fault, but which was as the original one. The vertical movement is blocked at 10 degrees, I would allow more movement here (about 30-40 degrees), as you may want to lower the shower head.
Printing
--
I used to print this with 40 % infill, but you may reduce this further.
Source
---
https://github.com/deflektor/3ddesign
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
