Shower holder

I created this shower holder to replace a commercial version that worked just for a couple of months.

**Requirements that led to this design:**
- Use the existing rod (26 mm diameter, actually this design can also be used with lower diameters)
- Holder can be easly moved up and down on the rod
- The inclination of the shower head can be adjusted
- All adjustments must be performed using one hand only

__The following not printable parts are required:__
- 2x screws M3x20 or M3x22 (cheese head)
- 2x nuts (M3)
- 2x springs 10.5x43.5x1.3 (the length of the springs must be adjusted)

__Assembly__
Shower holder consiste of 15 parts:
The assembly sequence is shown in the following video
https://youtu.be/8tEEcKI3wUw

__NOTES:__ This design is a work in progress.Once printed, assembled and installed it works fine, but durability test is currently in progress ;-)
For the printing I used PLA: probably PETG is a better choice.