Shower mirror hook

April 6, 2020 Updated the design. Mirror Hook v10 had been added.

- beefed up the body thickness in a few areas
- extended the tail hook
- added the version mark

I print at 70% infill and it takes around 3 and a half hours to print.
Uses approximately 23 grams of material. Total cost of materials: 52.9 cents

Rj

--------------------------------------------------------------------------------------------------------------
Using my trusty shower mirror to shave had served me well until I moved into my new place. Now the only location in the shower I could suction cup to the wall, had the bathroom light right behind it. That made it difficult to see.

I designed this hook to go over the shower door so the mirror can be held on one side, while on the other side, it "clips" around the bottom edge of the shower door bar so it's held securely. The mirror's suction cups, drop into and are held by the contoured bar.

This prints as two pieces that will be assembled togethe