Thingiverse
Shower Riser Rod/Rail Bracket
von Sue3DDesigns
14
Downloads
12
Likes
0
Makes
Made to fit 23.5mm inside diameter shower riser rod tubes.
Has an integral locating lug to stop the rotation (twisting) of the shower rod, and there is a drip/breather hole in the round end.
This was printed in ASA so that it would be resistant to UV exposure and made it amenable to being acetone smoothed.
Has an integral locating lug to stop the rotation (twisting) of the shower rod, and there is a drip/breather hole in the round end.
This was printed in ASA so that it would be resistant to UV exposure and made it amenable to being acetone smoothed.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!