Thingiverse
Shutter-crank rivet locking washer
von LeChaletDuMaker
3
Downloads
2
Likes
0
Makes
A colleague of mine came yesterday, enquiring if i could make a replacement part for gis Shutter crank : this crank is locked with a free rivet to the shutter mecanism; a washer/tube used to avoid the rivet to move out.
Here is the replacement part. For a 4mm rivet, over a 19mm crank diameter. Refers to the Design specs PDF.
Printed on an Anet A8 at 0,06 with Cura 2.7. See provided setting file
Here is the replacement part. For a 4mm rivet, over a 19mm crank diameter. Refers to the Design specs PDF.
Printed on an Anet A8 at 0,06 with Cura 2.7. See provided setting file
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!