Thingiverse
Shutter Shades
von ZDC
19
Downloads
20
Likes
0
Makes
Printed on Prusa MK3
I redesigned from scratch using kataze design.
The snap together pieces to hard to attach the arms.
- 0.2mm layer height
I designed a 2mm holes to connect arms to main frames so you can use a M2 screw or a 1.75mm piece of filament for the hinge.
I also made the bottom of the arms so the hole does not go all the way though so using a piece a filament for the hinge it will not fall out the bottom.
I also attached a Step file for those that want to make their own designs easier in their CAD software.
I redesigned from scratch using kataze design.
The snap together pieces to hard to attach the arms.
- 0.2mm layer height
I designed a 2mm holes to connect arms to main frames so you can use a M2 screw or a 1.75mm piece of filament for the hinge.
I also made the bottom of the arms so the hole does not go all the way though so using a piece a filament for the hinge it will not fall out the bottom.
I also attached a Step file for those that want to make their own designs easier in their CAD software.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
