Thingiverse
Si-Tech Quick Glove Wrench
von Scubapeks
4
Downloads
1
Likes
0
Makes
his is a wrench to remove your Si-Tech Quick Glove system after a dive. It sometimes get very hard to remove so I wanted a wrench to ease the process when needed.
V1 file is the entire wrench (won't fit on an Ender 3 builtplate).
V2 file will allow you to print it on an Ender 3 builtplate.
*The wrench has been fully tested before publishing.
V1 file is the entire wrench (won't fit on an Ender 3 builtplate).
V2 file will allow you to print it on an Ender 3 builtplate.
*The wrench has been fully tested before publishing.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!