Side shield for glasses

Side shields for your glasses that easily clip on to the legs of your spectacles, they are 35mm long and can be easily removed. My glasses used the 7mm version but I made a few more so others may use them too! These come in handy in shooting sports where you may have small pieces of copper jackets or lead flinging all over the place.

For sizing: measure the height of the legs on your glasses about 10-15mm from the forward end and pick the corresponding size, mirror it to get your other side as I only included right. If the legs have more than 1mm of taper along the 35mm length of the side shield you may not be able to get these to stay in place, you can wrap some tape around the legs to even out the taper some.

These side shields print well without supports at less than two and a half meters for the pair! Mine is printed in Elegoo PETG PRO in translucent burgundy red, 0.2mm layers, 2 walls and I set my floors and roofs to 100 layer heights so it prints solid. I orient it so the edges