Sidecar Ender 3 Electronics case

** Please NOTE ** this design is for the SKR 1.4 motherboards I have not tested it for any other; I DONT believe it will work for the standard Creality boards!
**
Why it exists!

There are many electronics case designs out there for the Ender 3 but none of them fitted my particular use case.

I wanted the electronics easily accsessible so if I needed to do something i didnt have to dissassmble the printer just pop the lid off while the printer was "in situ" . Also coming from a performance PC background it struck me that the cooling and cable management of most solutions was somewhat lacking.

The case is designed to sit at the side of the printer opposite the PSU with a 40x10mm fan at the bottom (in the pedastal) to pull cool air in and another 40x10mm at the top to push warm air out providing a chimmney effect and an air stream across stepper diver heatsinks.

The case is LARGE! for a number of reasons,
1. It gives better airflow both above and below the motherboard
2. I