Slicer Discord
SidePenHolder – 3D printable model from Thingiverse Thingiverse

SidePenHolder

25 Downloads
13 Likes
0 Makes
Go to Model
책꽂이나 책상 수직벽에 설치하는 공간 절약형 연필꽂이며 연필 비스무리히게 생긴 공구나 드라이버, 칼 등을 꽂아 놓을 수도 있다.
폭은 21미리이며 높이는 15, 18, 22로 각 2단씩 총 6단이며 최상단은 활짝 개방되어 있어 하나 더 놓을 수 있다.
아래로 10도 완만하게 기울어져 있어 평형 상태에서는 펜이 흘러 내리지 않으며 뽑아서 쓰기 쉽도록 만들었다.
서포트는 필요 없고 M3 나사 4개로 벽에 고정하면 된다.
책꽂이 벽 기준으로 왼쪽, 오른쪽 두 가지 타입이 있으며 양쪽으로 또는 아래 위로 적층해서 설치하는 것도 가능하다.

(쟤네들이 한글을 모르니 영어로도 써야겠네)

It is a space-saving pencil holder that can be installed on a bookshelf or desk vertical wall, and can also hold pencil-like tools, screwdriver, and knife
The width is 21mm, and the height is 15, 18, and 22, so there are a total of 6 stages, 2 stages each.
It is gently tilted down by 10 degrees, so the pen does not flow down in a balanced state, and it is easy to pull out.
No supports are needed, just fix it to the wall with 4 M3 screws.
There are two types, left and right, based on the wall, and it is possible to install them on both sides or stacked up and down.

Thank you

Source
Thingiverse
What you need to print this: Beginner Low confidence
Why?
no supports
Support-free Single piece Hardware needed
Supports 0/3
Assembly 0/3
Settings 1/3
Bed size 0/3
Post-process 1/3
Printer
FDM / FFF
File format
STL
Material
Post-processing
Hardware
Software
Cura, PrusaSlicer, or similar
No ratings yet
No comments yet – be the first!

Similar Models

6 Suggestions
Feed Blog Slicer Cost Calculator Image Search Submit Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Add to Collection