Thingiverse
Sidesword bookmarker
von SrdjanSavic
1
Downloads
9
Likes
0
Makes
Simple sidesword bookmarker. This model was created some time ago, and I printed probably a hundred. Most of them were given away at HEMA events.
Sorry there are not many pictures.
The one without side rings prints better on my old printer.
One thing to note, wait for the print bed to cool before removing. Sword tends to bend if pulled of the print bed while its hot.
It does not take a lot of filament, so I mostly printed this model whenever I had some leftovers.
Hope you like it.
Sorry there are not many pictures.
The one without side rings prints better on my old printer.
One thing to note, wait for the print bed to cool before removing. Sword tends to bend if pulled of the print bed while its hot.
It does not take a lot of filament, so I mostly printed this model whenever I had some leftovers.
Hope you like it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
