Slicer Discord
Sidewinder inspired Utility Knife – 3D-printbaar model van MakerWorld MakerWorld
Hand Tools

Sidewinder inspired Utility Knife

door mroven · Hand Tools
2.3k Downloads
1.4k Likes
1.4k Makes
Model downloaden
A cool little utility blade handle inspired by the Sidewinder mini knife. Updated New model replaces the “lock" with a screw for easier assembly. Redesigned the “lanyard loop” to eliminate need for support material. Also added better assembly photos. Prints with minimal supports, use PLA or any suitable filament. Requires the following additional hardware:(5) M3x16mm screws(1) M3x6mm screw(1) M3 hex nutStandard Utility bladeAssemblyOrient the handle pieces with “top back” and “bottom back” towards the back. These 2 pieces have smaller screw holes to allow you to thread the M3 screws in.“top front” and “top back” have an extra hole to accommodate a “lock” screw. The blade will lock into the shaft of this screw when closed.“bottom front” and “bottom back” have indentations to allow for clearance when closing. These pieces form the bottom on the handle.When everything is assembled, you should get a nice, satisfying “click” when closing.To open, give the thumb lever a pull towards the
Categorie
Hand Tools
Bron
MakerWorld
Gepubliceerd
Bijgewerkt
Wat je nodig hebt om te printen: Gemiddeld Lage betrouwbaarheid
Waarom?
2-delige montage
Hardware nodig
Supports 1/3
Montage 1/3
Instellingen 1/3
Bedgrootte 0/3
Nabewerking 1/3
Printer
FDM / FFF
Bestandsformaat
STL
Materiaal
PLA
Nabewerking
Hardware
Software
Cura, PrusaSlicer of vergelijkbaar
Nog geen beoordelingen
Nog geen reacties – wees de eerste!

Vergelijkbare modellen

1 Suggesties
Feed Blog Slicer Kostenrekenmachine Zoeken op afbeelding Indienen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Toevoegen aan collectie