Thingiverse
Sidewinder X1 gantry support
door xyster
2
Downloads
1
Likes
0
Makes
Just sharing; I'd suggest you validate and review before using.
Requires just some 1/4" threaded rod; no additional screws. Stiffens the gantry of the Sidewinder X1.
why 1/4" , well, because it's what I had laying around the house. 1/2" would be better probably, as 1/4" still has a bit of flex.
20% infill worked for me.
You print two of the lower pieces, one for left and right side; they probably could be tweaked a bit, as they don't fit 100%, but they stay in place well enough. no screws needed to hold them in place I find.
Requires just some 1/4" threaded rod; no additional screws. Stiffens the gantry of the Sidewinder X1.
why 1/4" , well, because it's what I had laying around the house. 1/2" would be better probably, as 1/4" still has a bit of flex.
20% infill worked for me.
You print two of the lower pieces, one for left and right side; they probably could be tweaked a bit, as they don't fit 100%, but they stay in place well enough. no screws needed to hold them in place I find.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!