Thingiverse
Sidewinder X1 LED bar
door Alter3go
249
Downloads
148
Likes
0
Makes
Requirements:
This bar fits a standard LED strip.
A 5v strip works perfectly, because on the mainboard, there is an open 5v slot (see the included picture for reference).
I used a set of Dupond connectors to plug into the mainboard and then fed the 2 wires up over the standard ribbon cable and covered them with similar black material tape that is used on the printer to cover the standard wiring.
and that's it, Bob's your uncle
This bar fits a standard LED strip.
A 5v strip works perfectly, because on the mainboard, there is an open 5v slot (see the included picture for reference).
I used a set of Dupond connectors to plug into the mainboard and then fed the 2 wires up over the standard ribbon cable and covered them with similar black material tape that is used on the printer to cover the standard wiring.
and that's it, Bob's your uncle
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!