Sidewinder X1 Tool Holders

Left and Right side tool holders for the Artillery Sidewinder X1. I use them to hold my print remover on the R side and on the L it holds the 4 Allen drivers i use the most 3mm, 2.5mm, 2mm, 1.5mm, a set of small flushcuts and a brush. These bolt on using the two bolts on either side of the printer using existing bolts and holes.

The holes for the tools are 3mm and 4mm

The rectangular cutouts are to save material and also to give some small areas to put bolts removed where they cant roll away.

I made cutouts where the bolts go so that if i wanted to use those bolts to hang something off the side of the printer or mount anything else it could go on top of the tool holder.

Depending on how rigid your material is you may have to put a small strip of double sided tape at the end furthest from the bolts to keep it from lifting that end up when you properly tighten the bolts. This happened with the purple so i switched to the more rigid black PLA i had.