Sidewinder X2 Z-Axis Stabiliser Brackets

LOWER Brackets:
Taken from here. https://www.thingiverse.com/thing:5223887
(I recommend you use supports if printing flat on the bed.

UPPER Brackets:
Use my version designed from scratch.
TWO will be required

HARDWARE:
Stainless steel preferred for looks
1) Designed for 10mm threaded bar. 2 lengths of 595mm required (imperial option us 3/8" rod, its a little smaller than M10 but will still work (thank you to Nelenfelix for that))
2) M10 Nuts ( 8 required )
3) M10 Washers (8 Required)
4) M5 x 12mm (or 15mm) screws required for the upper brackets (4 screws required)

ASSEMBLY TIPS:

Attached the lower brackets first.
Put 2 nuts and washers on each bar for the inner faces.
Thread the bar into the lower bracket and attach the lower nut (include washer)
Tread the upper bracket over the bar and attach (loosely) to the printer.
Tighten the Lower bracket M10 bolts to hold the bar firmly.
Tighten the upper brackets to the printer.
Add the final M10 nut with washer