Sigma Boy Sigma Boy

Hello I hope you enjoy my prints I'm pretty new at this but I do put lots of time to make sure these are perfect. Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mmThe Model is 120x120mm in sizeYou may print at higher layer heights below the Min Depth of 1mmThe Max Depth is 3mm and the Actual Depth is 2mmFilaments Used: PLA PolyLite Black Transmission Distance: 5.8 PLA BambuLab Tough Gray Transmission Distance: 2 PLA PolyLite White Transmission Distance: 5This print uses 3 unique filamentsSwap Instructions: Start with Black At layer #16 (1.36mm) swap to Gray At layer #17 (1.44mm) swap to White for the rest. WARNING… make sure let it cool down before removing or it will be warped it won't take long to cool.Boost Meplease leave a tip if you enjoy. Thanks