Thingiverse
Electronics
Model downloaden
Silent HDD mount
71
Downloads
63
Likes
1
Makes
This is a custom hdd holder bay, which holds a hard disc with rubber cord.
It is intended to isolate the disc vibration from the case, in order to reduce overall noise from your pc.
I used it in a custom build case, however it should fit in the larger slots in most cases. Keep in mind that it might be a little fidgety to get the disc holder part to move freely, since space is limited.
You need to print:
2 x Side
1 x DiskTray
In addition to the printed parts you need approximately 2 meters of 2mm thick rubber cord.
It is intended to isolate the disc vibration from the case, in order to reduce overall noise from your pc.
I used it in a custom build case, however it should fit in the larger slots in most cases. Keep in mind that it might be a little fidgety to get the disc holder part to move freely, since space is limited.
You need to print:
2 x Side
1 x DiskTray
In addition to the printed parts you need approximately 2 meters of 2mm thick rubber cord.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
