Thingiverse
Silhouette Coin
von MeesterED
6
Downloads
6
Likes
0
Makes
This is a remix of Blank Makers Coin by RetromanIE.
The silhouette part was printed first and then the ring part was paused and the silhouette inserted during the print. The parts are firmly fused together.
There are 3 small triangles inside of the opening that should be visible if printed in high enough resolution to see when to install the silhouette. It was at 88 percent for me.
The ring part is Hatchbox Wood PLA and the center is AIO Robotics Black PLA.
The silhouette part was printed first and then the ring part was paused and the silhouette inserted during the print. The parts are firmly fused together.
There are 3 small triangles inside of the opening that should be visible if printed in high enough resolution to see when to install the silhouette. It was at 88 percent for me.
The ring part is Hatchbox Wood PLA and the center is AIO Robotics Black PLA.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!