Thingiverse
sim racing e-brake upgrade
von clos2727
106
Downloads
65
Likes
0
Makes
these are all the essential for creating the parts to finish converting the e-brake.
video link soon to follow.
https://www.youtube.com/edit?video_id=YohqfujYAB4
e- brake frame being used for this build
http://www.ebay.com/itm/RED-HYDRAULIC-HORIZONTAL-RACING-DRIFT-RALLY-HAND-E-BRAKE-PARKING-HANDBRAKE-LEVER-/252447731174?hash=item3ac70eade6:g:3FMAAOSwvg9XeKFT&vxp=mtr
all prints are 100% infill @ 0.4 layer.
each part takes about three hours to print
Shifter handle takes about 10 hours. not necessary. can use the handle that originally came with the kit.
The pull handle has a 3/8ths hole in the center. use an open end 3/8 bolt and screw it in the hole as far as it will go. then attach your choice universal knob with set screw and spacers.
if you would like me to print them out and ship them to you, or just have any questions. hit me up on facebook at
https://www.facebook.com/clos27reyes/
video link soon to follow.
https://www.youtube.com/edit?video_id=YohqfujYAB4
e- brake frame being used for this build
http://www.ebay.com/itm/RED-HYDRAULIC-HORIZONTAL-RACING-DRIFT-RALLY-HAND-E-BRAKE-PARKING-HANDBRAKE-LEVER-/252447731174?hash=item3ac70eade6:g:3FMAAOSwvg9XeKFT&vxp=mtr
all prints are 100% infill @ 0.4 layer.
each part takes about three hours to print
Shifter handle takes about 10 hours. not necessary. can use the handle that originally came with the kit.
The pull handle has a 3/8ths hole in the center. use an open end 3/8 bolt and screw it in the hole as far as it will go. then attach your choice universal knob with set screw and spacers.
if you would like me to print them out and ship them to you, or just have any questions. hit me up on facebook at
https://www.facebook.com/clos27reyes/
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
