Thingiverse
SimLab Vertical Mount Facia USB Mount
door RCHeliGuy
4
Downloads
7
Likes
0
Makes
This is a two piece DIN USB mount for a Precision Sim Engineering Wheel through a SimLab Vertical mount without the cable touching the opening.
it has a front face that attaches to the rear section with the USB mount.
It may be compatible with other round DIN designs. The M3 bolt holes are on a 20mm OC square pattern. and the center clearance is about 21mm.
The two halves are bolted together using 7x M3x16 socket head screws and square nuts.
The square holes are pressure fit require needle nose pliers to press into place. An ice pick or very small screwdriver can help to center the nuts.
The USB mount takes 4 x M3x20mm bolts and locknuts to secure the DIN face
it has a front face that attaches to the rear section with the USB mount.
It may be compatible with other round DIN designs. The M3 bolt holes are on a 20mm OC square pattern. and the center clearance is about 21mm.
The two halves are bolted together using 7x M3x16 socket head screws and square nuts.
The square holes are pressure fit require needle nose pliers to press into place. An ice pick or very small screwdriver can help to center the nuts.
The USB mount takes 4 x M3x20mm bolts and locknuts to secure the DIN face
RCHeliGuy publiceert ook op
47 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!