Thingiverse
Simple 1W LED Clip
door RyusLightworks
67
Downloads
54
Likes
0
Makes
A little clip for 1W LEDs. Should be pretty standard dimensions. You normally get these already soldered on a star shaped aluminium plate with solder contacts. But you can also get these without the star patch a lot cheaper. Just keep in mind that they are meant to be soldered to such a star patch to have some cooling, without it they get too hot at full power.
I made this to add some light to my printer, these clips are meant to be tied to the frame using cable ties. Four of those with a little power reduction so they son't run hot produce so much light that the printer illuminates the whole room.
The clips are designed that the LEDs have a very tight fit. But with a little pressure they should go in and stay there.
I made this to add some light to my printer, these clips are meant to be tied to the frame using cable ties. Four of those with a little power reduction so they son't run hot produce so much light that the printer illuminates the whole room.
The clips are designed that the LEDs have a very tight fit. But with a little pressure they should go in and stay there.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
