MakerWorld
Office
Model downloaden
Simple 2-Screw Wall Hook (Tested Design)
28
Downloads
9
Likes
7
Makes
This is a clean, minimal wall-mounted hook designed for everyday organization using only two screws. The model is optimized for easy printing and requires no supports. The hook has been physically tested and is designed with practicality and simplicity in mind. The hook was printed on it's side in PLA at 15% infill and failed at about 15kg. Mounting:2× M3 countersunk screws (recommended length: 16–20 mm depending on wall)Print Orientation:Print flat with the side on the build plateSupports:Not requiredInfill Guidance:Light use: 15% gyroidHigher loads: 30–35% gyroidWall Count Recommendation:Strength improves with increased wall count (4–5 walls recommended for heavier use)
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
