Thingiverse
Simple 2D Snowman
von Frothyexe
1
Downloads
3
Likes
0
Makes
Simple snowman decoration for Christmas.
The model comes in two parts, the body and the stand, so you will need to superglue them together.
I printed this with 1.5mm layer height, which worked out well and only took 12 minutes for me.
The actual model is about 40 mm high (1.575 inches), but you can remix it to make it bigger if you prefer.
The model comes in two parts, the body and the stand, so you will need to superglue them together.
I printed this with 1.5mm layer height, which worked out well and only took 12 minutes for me.
The actual model is about 40 mm high (1.575 inches), but you can remix it to make it bigger if you prefer.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!