Simple Bird Feeder

Edit 21Mar2022: I printed this part but had to reprint the roof due to a power failure. Then I glued the new roof on top. Anyway, this will print as one piece but I would recommend scaling down a bit as it is quite big.

This is a simple bird feeder I designed for mounting or hanging outside our apartment. As of today (3/7/22) I have not printed this yet but I plan to sometime in the next 2 weeks. This should print fine with no supports. There is a hole in the bottom/center for mounting on a 20mm post and I designed the bracket with this in mind. Our apartment has a 50mm dia railing which the bracket was designed for. Understanding most people do not have this particular size railing, there is also a hole for hanging the feeder. (If you do use the bracket it can be secured with 2 M5x20mm screws and nuts)

I expect to use standard Cura settings and I can post those later if there is any interest. Also please note, this will likely be a little too big for an Ender 3 build plate, so w