Thingiverse
Simple church
von scr3wballl
78
Downloads
138
Likes
0
Makes
THIS IS STILL A WORK IN PROGRESS
Simple church, original size 110mm height (to peak without the roof on) x 65mm width. With the roof on, at 100% scale, it should be 15cm (150mm) tall. I printed it without a raft and no supports with black PLA, although I did use a brim skirt to help with adhesion.
Simple church, original size 110mm height (to peak without the roof on) x 65mm width. With the roof on, at 100% scale, it should be 15cm (150mm) tall. I printed it without a raft and no supports with black PLA, although I did use a brim skirt to help with adhesion.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!