Thingiverse
Simple CR10 Brace Mod
door 3DPengn
236
Downloads
122
Likes
4
Makes
Description:
This mod is a minimal design for adding braces to the CR10. The brackets holding the brace in place slide into the vslot railing and hold tight enough not to require any additional screws, aside from the threaded post its self. You will need to print two of each type of bracket. You will then need to add one of each bracket type to each threaded post and secure them in place with a nylon locking nut on either side of the bracket. There will be some adjusting needed to get the bracket pieces in just the right position to fit on the printer. The vslot rail by somaraok, listed under the remix, was utilized in this print to help get the shape for the brackets to slide into the vslot railing.
Materials:
1/4 inch threaded post 24 inches long - 2
1/4 inch nylon lock nut - 8
Print Details:
Filament: PLA +
Infill: 25%
Layer Height: 0.3 mm
Support: No
This mod is a minimal design for adding braces to the CR10. The brackets holding the brace in place slide into the vslot railing and hold tight enough not to require any additional screws, aside from the threaded post its self. You will need to print two of each type of bracket. You will then need to add one of each bracket type to each threaded post and secure them in place with a nylon locking nut on either side of the bracket. There will be some adjusting needed to get the bracket pieces in just the right position to fit on the printer. The vslot rail by somaraok, listed under the remix, was utilized in this print to help get the shape for the brackets to slide into the vslot railing.
Materials:
1/4 inch threaded post 24 inches long - 2
1/4 inch nylon lock nut - 8
Print Details:
Filament: PLA +
Infill: 25%
Layer Height: 0.3 mm
Support: No
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
