Thingiverse
Simple diffuser for 50 mm LED spot
door DrLex
33
Downloads
21
Likes
0
Makes
This is a simple dome-shaped diffuser for a common type of LED spot with 3 LEDs and a 50 mm outside diameter. It comes in a smooth and low-poly version. The latter may be somewhat easier to print. Supports should not be necessary, but you will definitely need adequate cooling to print the large internal bridges and steep overhangs. A brim may also be a good idea, although it should not be necessary with good adhesion.
If it is too tight or loose, scale it up or down by a few fractions of a percent.
If it is too tight or loose, scale it up or down by a few fractions of a percent.
DrLex publiceert ook op
29 extra modellen op 2 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
