Thingiverse
Simple Filament Spool holder
von up_cycle
0
Downloads
0
Likes
0
Makes
This is a very simple spool holder for your 3D-printer.
All you need is:
4x "Rollenhalter v1"
4x roller bearings (inner diameter 5mm outer 11mm thickness not critical e.g 5mm)
2x M5 bolts
depending on the precision of your 3D-printer you can screw the bolts directly into the plastic or use nuts to secure them → then u need 2x M5 nuts (with washers)
All you need is:
4x "Rollenhalter v1"
4x roller bearings (inner diameter 5mm outer 11mm thickness not critical e.g 5mm)
2x M5 bolts
depending on the precision of your 3D-printer you can screw the bolts directly into the plastic or use nuts to secure them → then u need 2x M5 nuts (with washers)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!