Thingiverse
Simple Filament Spool Stand V3.2
door FablabMoebius
2.9k
Downloads
2.3k
Likes
67
Makes
##Even better
##[Update V3.2]
**Less tight bars available!**
Depending what you need, default bars are tight to have a strong hold. If it's too tight for your printer, use the "less tight" versions. This is for the width of the bars (not the size of the notch)
##[Update V3.1]
**Even more simple to print !**
With square bases, the bars are impossible to miss !
##V3.0
Even more simple than my **Simple Filament Spool Stand V2** (http://www.thingiverse.com/thing:281848).
##Just print and clip !
**No additional parts needed**, you just print 2 sides + 1 bar, you clip them and you're done !!
**No bearings**, **No screws**, **No washers** !!
Just print and clip !
This version works with **Standard Spools of 1Kg of 1.75mm** filament and Printrbot spools.
[update:]The stand is 10 cm tall. So it's very easy to scale up (110% will give you 11cm tall, 120% > 12cm and so on).
**[update 04/25/14:] Following people's requests, i added 2 new length bars : 130 mm long an
##[Update V3.2]
**Less tight bars available!**
Depending what you need, default bars are tight to have a strong hold. If it's too tight for your printer, use the "less tight" versions. This is for the width of the bars (not the size of the notch)
##[Update V3.1]
**Even more simple to print !**
With square bases, the bars are impossible to miss !
##V3.0
Even more simple than my **Simple Filament Spool Stand V2** (http://www.thingiverse.com/thing:281848).
##Just print and clip !
**No additional parts needed**, you just print 2 sides + 1 bar, you clip them and you're done !!
**No bearings**, **No screws**, **No washers** !!
Just print and clip !
This version works with **Standard Spools of 1Kg of 1.75mm** filament and Printrbot spools.
[update:]The stand is 10 cm tall. So it's very easy to scale up (110% will give you 11cm tall, 120% > 12cm and so on).
**[update 04/25/14:] Following people's requests, i added 2 new length bars : 130 mm long an
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
