Thingiverse
Simple Frog House
von usaohmmeters
23
Downloads
19
Likes
0
Makes
Wife wanted a frog house so I fired up the (ok...its never "off" per say) CR10 S5
This is the frog I used and scaled up to fit my needs: https://www.thingiverse.com/thing:2136760
Base was printed at .2 and 3000mm/min @ 20% infill; no supports
Top was printed at .2 and 3000mm/min @ 20% infill; with supports
Attached frog with Gorilla glue
All printed in Solutech PLA
Sliced with S3D
Designed in AD Inventor
This is the frog I used and scaled up to fit my needs: https://www.thingiverse.com/thing:2136760
Base was printed at .2 and 3000mm/min @ 20% infill; no supports
Top was printed at .2 and 3000mm/min @ 20% infill; with supports
Attached frog with Gorilla glue
All printed in Solutech PLA
Sliced with S3D
Designed in AD Inventor
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!