Simple Garden Hook

My mom asked for the potters to hang 8 inches lower, so i made a simple hook! It's a half inch thick and printed with 30% infill, ran some stress simulations on it and it doesn't break with a load of 40 pounds. So far these hooks have held up to heat, wind, cold and rain and have not deteriorated much, so these should be good for awhile. They fit onto the hooks in the last pic, and the hook I made has a small indent to attach with.

Had to scale down to fit on my bed (weird cura glitch) but it fits in the volume fine. I scaled it to 90% for reference and it printed fine!

Printed with 0.28mm layers and it took 2 hours and change. Filament used was eSun PLA+ Green.