Simple Handle (No Supports)

Simple swept-arc door handle with designed to be printed on its side. The mounting holes are 4mm diameter with a 6mm diameter screw inset for flush mounting with wood screws.

Intended to be printed on its side so that the layer lines resist pulling force.
Support should not be needed for this handle, but an easily removable support could be added to each 4mm hole if you get any filament sagging during the print.

Two sizes included; "regular" size has a 70mm internal clearance from one end to the other. If you need to get your whole hand grip in underneath the handle, the large version has a 90mm clearance.