MakerWorld
Organizers
Go to Model
Simple Hinged Box with Ribs
9
Downloads
0
Likes
0
Makes
This is a simple hinged box using 3 printed parts. The box model does need support but only under the latch. A latch holder is also present in the design, allowing you to open the box with ease, and close it conveniently, without allowing anything to fall out. A piston holds both the latch and the box together, acting as the hinge, but don't worry, it is created by just cutting down 1.75 mm filament! To do this, place a piece of filament through each hole and cut down to the correct length, making sure it is flush with the box. Enjoy! NOTE: If the holes look a little rough, I used a 5/64 drillbit to clean them up, but this shouldn't be to much of an issue. Print Settings:Supports, 10% infill, 0.2 mm Layer Height
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!