Slicer Discord
Simple Indoor Glider V2 – 3D-Druckmodell von MakerWorld MakerWorld
Vehicles

Simple Indoor Glider V2

2.9k Downloads
490 Likes
2.7k Makes
Zum Modell
This project is the culmination of 100+ hours of remodeling and printing. There was no miniature handheld glider that could be printed and thrown straight all in less than a half hour, which I wanted to change The main features of the glider are its unparalleled accuracy and consistently, allowing a skilled used to soar the plane 30 feet before it lowers by even an inch. Pitch Stability Yaw Stability Ease Of Use Consistency Durability Airtime ★★★★★ ★★★★★ ★★★★ ★★★★★ ★★★ ★★★★★ This was printed on the Bambu P1P and printed in 23 minutes(17 minutes of actual printing) with white PLA basic. It used just under 10 grams of filament.Instructions-Print in PLA at 100% infill with no brim or raft. Wait for the hotbed to cooldown before gently using a scraper tool to remove the glider.Bend the tail segments up 90 degrees.Bend the elevators down about 25 degrees, and flip over the plane.Hold the glider from between the main and tail wings, and throw lightly. The tail segments should be facing downw
Kategorie
Vehicles
Quelle
MakerWorld
Veröffentlicht
Aktualisiert
Was du zum Drucken brauchst: Mittel Niedrige Konfidenz
Warum?
Supports nötig
Einteilig Supports nötig
Supports 2/3
Zusammenbau 0/3
Einstellungen 1/3
Druckbett 0/3
Nachbearbeitung 0/3
Drucker
FDM / FFF
Dateiformat
STL
Material
PLA
Software
Cura, PrusaSlicer o. Ä.
Noch keine Bewertungen
Noch keine Kommentare – sei der Erste!

Ähnliche Modelle

6 Vorschläge
Feed Blog Slicer Kostenrechner Bildersuche Einreichen Kontakt Discord ☕ Buy me a coffee
DE EN FR ES IT NL

Zur Sammlung hinzufügen