Simple Large Brick Wreath Alignment Jig

This is a simple jig for the large brick decorative wreath. There is another wreath jig on MakerWorld that ended up being too small for my size branches so I created this one. This jig is for what I am calling a ‘large’ branch, 168.731mm ‘square’ dimension as shown in BambuStudio, or approx 219.761mm from tip to end of the longest section.As these branches are much larger I was unable to create a complete circle jig, instead use this jig on the “inside” holes of two branches to get the proper angle for the circle (see images) then remove the jig and attach it to the next set of branches until you're all the way around. Depending on your tolerances this jig angle might be a little off, the jig pegs won't be dead center of the branch holes at any angle you try, however it still gets a better overall angle rather than eyeballing it.I've created 3 versions of the jig depending on how many branches you are using; 8, 7, or 6 branches.