Simple lead screw cover

Had issues with the full length lead screw cover breaking during installation or colliding with the bed (despite using magnets) and causing levelling failures so I designed a simpler take on it. Simple bracket that mounts using the bed screws and keeps a consistent distance from the bed. Helps to guide placement of the print bed and protect it from hitting the lead screw accidentally Installation instructions:Press down the bed at the front left corner and unscrew the left bed knob there by rotating clockwiseBe careful to not lose the washer sitting on top of the knob. It may be stuck to the underside of the bedPlace the print over the knob. The recess should fit over the center to hold it in placePlace the washer into the recess on the other sideReinstall the parts again by holding the bed pressed down strongly and screwing the knob on counter-clockwise. Aim for finger tightCheck that the print does not appear on the camera. If it does, you can adjust it by slightly loosening the bed