Thingiverse
Simple Magnet Bowl
von rickseiden
7
Downloads
2
Likes
0
Makes
This is a super simple magnet bowl. It has 6 holes for 6mmx3mm magnets in its bottom.
You can use it to hold on to small screws and stuff. I mean, it's really simple.
When I printed it out, the magnets were a very tight fit. I had to use the back of a screwdriver to force the magnets in, but if it wasn't tight, they'd fall out. You could probably print it at 102% or 103% to see if the magnets go in easier.
You really do need support for this. At least I did.
You can use it to hold on to small screws and stuff. I mean, it's really simple.
When I printed it out, the magnets were a very tight fit. I had to use the back of a screwdriver to force the magnets in, but if it wasn't tight, they'd fall out. You could probably print it at 102% or 103% to see if the magnets go in easier.
You really do need support for this. At least I did.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
