Simple Maker Select V2 Spool Holder

This print is not very polished and very few test prints were done, it was a print out of necessity after breaking my Maker Select V2 spool holder, if you print as is you will need to source bearings of the right size and do a wee bit of sanding.

I had some bearings on hand of the 6203Z verity from another project; they have a 17mm id and a 40mm OD
I also had some 5/16ths threaded rod (roughly 8mm) from a Z axis stability mod that’s a work in progress so I worked with what I had at the time.

This is a simple roller bearing spool holder type and works just fantastically for me

A few notes, Different types and sizes of bearings would probably work better as these are designed for a strenuous machine load and are packed with grease meaning they don't turn very easily, but they work fine for me even with an empty spool and are smooth enough not to matter if they spin at all

the CD on the end is not necessary if you use a slightly smaller bearing and probably not even at all