Thingiverse
Simple PCB Holder
por alfiemalfie
56
Descargas
48
Likes
0
Makes
Updated May 2018 - better block (v2)
A simple holder for PCB work.
Print 2 of each STL file. (use V2 block)
Push an M6 bolt through the top hole of a frame, slip on a spring (washers optional) and glue into a block.
Repeat.
2 pieces of M8 threaded bar through the bottom 2 holes. slide together to hold PCB, end frames will grip the threaded rod.
Wrap an elastic band around the each end of each thread if required or add some M8 nuts to cinch it up.
Simple :)
Hardware required
* M6 bolt x2
* spring x2
* washers x4 (optional)
* M8 threaded bar - cut to any length you want (or 8mm wooden dowel)
* Hot-melt glue or similar
* Rubber bands - to hold frames (optional)
* M8 nuts - to hold frames (optional)
A simple holder for PCB work.
Print 2 of each STL file. (use V2 block)
Push an M6 bolt through the top hole of a frame, slip on a spring (washers optional) and glue into a block.
Repeat.
2 pieces of M8 threaded bar through the bottom 2 holes. slide together to hold PCB, end frames will grip the threaded rod.
Wrap an elastic band around the each end of each thread if required or add some M8 nuts to cinch it up.
Simple :)
Hardware required
* M6 bolt x2
* spring x2
* washers x4 (optional)
* M8 threaded bar - cut to any length you want (or 8mm wooden dowel)
* Hot-melt glue or similar
* Rubber bands - to hold frames (optional)
* M8 nuts - to hold frames (optional)
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
