Thingiverse
Simple Phone Stand
by Maxotron
1
Downloads
0
Likes
0
Makes
The phone stand is 3.15in x 6.3in at a 60 degree angle.
80mm x 160mm
It will print better on its' side and you could even print at 10% infill.
If you use the Bambu Labs P1S, it will take a little over 2 hours to print.
80mm x 160mm
It will print better on its' side and you could even print at 10% infill.
If you use the Bambu Labs P1S, it will take a little over 2 hours to print.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
