simple photo or note stacker

Stack (freshly scanned) photos or other flat things, like slips of paper.

This is a variant of my film strip stacker in sizes large enough to stack photos (prints).

It is just as much a quick hack as the film stackers. Just don’t break of the side plates.

There are meshes for different sizes ready:

* 8 cm × 12 cm
* 9 cm × 13 cm
* 10 cm × 15 cm

If you need other sizes, you should use OpenSCAD on your own computer. This was a quick hack, and i cba to make this work with the customizer.

Unfortunately i forgot to take pictures of these before i finished scanning my photos and then binned these things.