Simple Power Plugs Hooks

I have a lot of electrical devices that are in my office but most of these don't have to be constantly plugged.

I was fed to constantly crawl under the desk to gather the cables which have fallen on the floor so I had to make a quick & simple way to keep them at my disposal and not far from the outlet.

This is the first model I made to manage these and it actually do the job.
The tricky part was to make the two pressure clips that may keep the support in place without breaking. I was lucky this worked on the first try without the need of any reinforcement.

Also to prevent warping, I added two small pins under it so the slicer will fill it with supports. So post-printing smoothing has to be made to get a clean object.

It is designed to clip on a 18mm thick plank which is quite common.
If you need to get another thickness and don't know how to edit the file, I will gladly do it for you.