Gadgets
Model downloaden
Simple Programmable Turntable for 3D Scanning (Photogrammetry)
270
Downloads
251
Likes
2
Makes
Just a simple turntable for use in 3d scanning (actually photogrammetry) or anything else that you can think of.
This is an easy print and all you need is a stepper motor, three ball bearings, and an Arduino (together for considerably less than USD 10).
- Stepper motor 28BYJ-48 (5V 4 Phase) + ULN2003 Driver Board (should be less than USD 2 together)
- Arduino (once again less than USD 2 - I have been using the Arduino Nano for most of my projects but you can of course just as well use an Uno)
- Four 608 (ZZ or RS or 2RS) ball bearings (once again < USD 2)
Put the stepper in the mount in the center of the case, connect it to the Arduino via driver board, stick the ball bearings on the four axes, stick the feet in, and add the turn table. You are (almost) there.
All you need is a few lines of code adapted to your needs (which could be continuous turns, moving stepwise, a stop after every 10 degrees or....). The nice thing about using an Arduino is that it is fully progra
This is an easy print and all you need is a stepper motor, three ball bearings, and an Arduino (together for considerably less than USD 10).
- Stepper motor 28BYJ-48 (5V 4 Phase) + ULN2003 Driver Board (should be less than USD 2 together)
- Arduino (once again less than USD 2 - I have been using the Arduino Nano for most of my projects but you can of course just as well use an Uno)
- Four 608 (ZZ or RS or 2RS) ball bearings (once again < USD 2)
Put the stepper in the mount in the center of the case, connect it to the Arduino via driver board, stick the ball bearings on the four axes, stick the feet in, and add the turn table. You are (almost) there.
All you need is a few lines of code adapted to your needs (which could be continuous turns, moving stepwise, a stop after every 10 degrees or....). The nice thing about using an Arduino is that it is fully progra
guppyk publiceert ook op
13 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!